*Sign manOrWoman = null;

Possibly to deal with the ozone things like this can produce.

Or the router, in another state, and the person with access to the closet/server room knows how to push a few buttons at best.

That happens once… and you get misconfigophobia for life.

And utilities for identify the eventual duplicates to save space (while still ensuring you don’t have only 1 copy that can be corrupted)

Like anything else it’s always trade offs.

It’s also good to remember that Katrina’s storm surge and the subsequent failure of the levees and flooding of the city is what was so damaging.

Besides the wind and rain the destruction of the levees took a huge toll on New Orleans.

If I recall correctly it’s important to be running ECC memory right?

Otherwise corrupter bites/data can cause file system issues or loss.

If a person is at the intro/intermediate level that advice may be sound enough. Since they’re less likely to apply proper rules to include those ranges of IP’s etc.

Assuming it’s advising disabling it at the router/switch level and not just a per device level.

Better would be to explain: Disable this until you’re familiar with the following concepts (see cited books/material for more info)

What a mess… sounds like the devs got burned by various Unicode edge cases RTL, etc

Oof. That sounds horrible

Is it because of the lower case Latin æ since it’s technically one character even if two bytes?

Sounds like it’s actually using XSLT or some kind of content validation. Which to be honest sounds like a good practice.

It’s not a waste of time… it’s a waste of space. But it does allow you to “enforce” some schema. Which, very few people use that way and so, as a data store using JSON works better.

Or… we could go back to old school records where you store structs with certain defined lengths in a file.

You know what? XML isn’t looking so bad now.

If you want to break the AI ask instead what regex you should use to parse HTML.

Probably. But I didn’t want them dealing with being cut off. They can do what they want but since it’s a dorm you can be sure they’ve had these conversations before

This is for the A7 but may show you how to turn off wifi on yours if the UI is the same

https://community.tp-link.com/us/home/forum/topic/560824

Depends on whether you can adjust the Tx level but then you run into FCC level stuff that most people avoid (since boosting it is a huge issue with interference)

But this is a dorm. A shared environment with close proximity.

If everyone had their own Wi-Fi transmitting at normal power there would be too much interference that even channel hopping wouldn’t fix it.

Not to say that there can’t be some middle ground but the Wild West attitude isn’t kosher either.

Rf interference. Similar to having multiple microwaves running near your router, or those old rf based baby monitors.

Congested the 2.4 or 5gz spectrum with noise causing noise and retransmits or outright stopping the wifi from working.

If you have an old radio that does AM find a AM channel that isn’t broadcasting and bring it near your router. You can actually “hear” the noise those things are putting out.

Note that hiding its SSID won’t turn off the wireless broadcast which would be adding to the “noise” in whatever channel it’s using.

In this case you would want to turn off the wireless itself

I HAVE PEOPLE SKILLS!!!